# Copyright (c) ULBSD Project Team. All rights reserved.
# $Id: ulbsd-clone-msg-en 2 2020-04-06 16:44:15Z sv $

lang="en_US"
backtitle="ULBSD operating system cloner"
cancel_label=" Cancel "
yes_label=" Yes "
no_label=" No "
incorrect_msgbox_msg="  Error! Incorrect value!"
main_menu_msg="      Welcome to ULBSD cloner!"
main_menu_item_clone="(Clone the system)"
main_menu_item_reboot="(Reboot the workstation)"
main_menu_item_shutdown="(Shutdown the workstation)"
main_menu_item_exit="(Exit to command prompt)"
disk_no_avail_msgbox_msg="Error! There are no available disks!"
disk_menu_msg="         Select destination disk:"
disk_menu_help_label="    Info    "
disk_info_msgbox_msg="All available disks info: "
swap_inputbox_msg="Enter the size of swap partition in megabytes. It is recommended that the size should be\nabout double of system memory (RAM), but not necessary. You can disable the swap by leaving this field blank:"
fs_menu_msg="       Select destination file system to create:"
fs_menu_item_ufs="Unix File System (RECOMMENDED)"
fs_menu_item_zfs="Zettabyte File System (EXPERIMENTAL)"
label_inputbox_msg="Enter the value for root partition label (for ZFS pool name). Valid latin upper and lower case letters and numbers. Do not enter 'boot', 'efi' and 'swap'. For the root partition label and ZFS pool name the same value is used:"
final_yesno_msg_part1="Are you sure you want to start cloning?\nALL DATA ON THE DISK "
final_yesno_msg_part2=" WILL BE LOST!"
clone_prgbox_msg="Create a file system, cloning and configure..."
alldone_msgbox_msg="Try again if any errors occurs!\nOtherwise, shutdown the workstation and remove the source or destination drive!"
